Filter By:

  • Show More Brands

  • Show Fewer Brands
  • Show More Sizes
  • Show Fewer Sizes

Parts & Accessories

Wahoo RPM Cadence Sensor (BT/ANT+)
$39.99
The Wahoo RPM cadence sensor is your sleek little solution for measuring cycling cadence data. It is wireless, magnet-less, lightweight, and easily mounts to your bike's crank arm or to your shoe. Bluetooth Smart and ANT+ dual band technology allows you to connect to and display data on both smartphones and GPS bike computers. Collecting cadence data has never been this easy. - Both ANT+ and Bluetooth Smart capabilities allow for a wireless connection to both smartphones and bike computers. - No tangled wires on your bike to connect the sensor to your device. - It only weighs 7 grams! - Provides accurate cadence data during your ride - (1) mount with double sided 3M tape, or (2) use the silicone sleeve and mount with zip ties. - The RPM can be worn on your shoe for spin classes or use with multiple bikes - Two LED lights show the sensor's device connection (blue) and cadence detection (red) - No charging required! Operates on a coin cell battery for up to 1 years. - RPM cadence sensor will fit with most bikes and frame sizes
CycleOps BlueGiga USB Dongle
$29.99
The BlueGiga dongle gives Rouvy, CycleOps' virtual training software, the ability to seamlessly connect to Bluetooth devices and sensors. The BlueGiga dongle contains a Bluetooth (BLE) radio that allows PCs to communicate with BLE devices, including CycleOps smart indoor bicycle trainers and power meters made by the folks at PowerTap. Most importantly, the BlueGiga dongle is necessary to update the firmware Over the Air (OTA) via VirtualTraining for the Hammer and Magnus bike trainers. - Bluetooth dongle for PCs to work with Rouvy - Needed for Over the Air Firmware Updates to Smart Indoor Bike Trainers. - Works with PC desktops and laptops.
Wahoo ANT+ USB with Extension Cord
$39.99
Wahoo USB ANT+ dongle Kit connects KICKR, KICKR SNAP and other ANT+ enabled devices to a Mac or PC. The 3-foot extension cord extends the USB ANT+ transmitter away from the computer and towards the connected device to avoid signal interference.
CycleOps ANT+ Mini USB Stick
$38.99
Connect your desktop to CycleOps VirtualTraining.
Bontrager Blendr Garmin Low Mount
$19.99
Blendr is the ultimate integration system for clean and easy installation of lights, computers, and other accessories. Start with a Blendr stem, add the appropriate base, and finish with the Blendr Garmin Low Mount to add a Garmin GPS directly to the Blendr stem mount. Key features: - Blendr is an elegant, integrated accessory mounting solution - Provides clean and secure mount for Garmin GPS - Works with any Blendr-compatible stem and the accompanying base - For use with Blendr bases (Pro, XXX, XXX bar/stem, and select Elite bases)
Bontrager Blendr GoPro Mount
$19.99
Blendr is the ultimate system for clean and easy integrated installation of lights, computers, and other accessories. Start with a Blendr stem, add the appropriate base, and finish with the Blendr GoPro Mount for a clean, flush look that securely holds your GoPro in a centered location. Key features: - Blendr is an elegant, integrated accessory mounting solution - Provides clean and secure mount for GoPro camera - Works with any Blendr-compatible stem and the accompanying base - For use with Blendr bases (Pro, XXX, XXX bar/stem, and select Elite bases)
Wahoo RPM Speed Sensor (BT/ANT+)
$39.99
The Wahoo RPM speed sensor is the sleek, magnet-less solution for capturing cycling speed data. It easily mounts to your bike's front wheel hub, and the Bluetooth Smart and ANT+ dual band technology allow you to connect to and display data on both smartphones and bike computers. Tracking speed data has never been this easy. - Both ANT+ and Bluetooth Smart capabilities allow for a wireless connection to both smartphones and bike computers. - No tangled wires on your bike to connect the sensor to your device. - The RPM speed installs easily with no magnets required - It only weighs 16.5 grams with the mount included - Provides accurate speed data during your ride - Mounts on most front wheel hub with a secure silicone casing - Two LED lights show the sensor's device connection (blue) and speed detection (red) - No charging required! Operates on a coin cell battery for up to 1 years. - RPM Speed will fit with most bikes and frame sizes
Bontrager Insta-Mount
$13.99 $19.99 30% Off
Easily mount a cell phone and case directly to your bars for safe convenient access with the Insta-Mount and keep all of your favorite cycling and fitness apps safely accessible. • Mount your hard-shell smart phone case to your bike • Allows for easy access of phone on stem or handlebar • Includes Insta-Mount, universal mount, and application grid • Blendr-compatible
Bontrager Bontrager SpeedTrap Digital Speed Sensor
$34.99
Bontrager's SpeedTrap Digital Speed Sensor conveniently plugs into any Bontrager fork with SpeedTrap technology for the ultimate in convenience. And, it wirelessly transmits speed data to your ANT+ cycling computer.
CycleOps ANT+ Micro USB Adapter
$19.99
The ANT+ Micro USB adapter allows on-the-go devices (OTG), such as your Android phone or tablet, to connect to an ANT+ USB stick. Android OTG compatible devices require ANT+ Radio Service and ANT+ USB Service to be installed from the Google Play store. These services allow the adapter to work correctly with an ANT+ USB stick.
Bontrager Computer Batteries
$5.99
Keep your computer and sensors ready for every ride with replacement batteries Key features: - CR2032 battery is used for most Trek and Bontrager computers - 23AE battery is used for the Bontrager Interchange Analog Wireless Sensor - LR44 and L1154 batteries are identical and used in Bontrager SpeedTrap Sensor
Quarq ShockWiz Spares - Hose Kit
$50.00
Spare hose kit for Quarq's ShockWiz automated suspension tuning device. - Contains one of each hose type and four zip ties.
SRAM eTap BlipGrip
$21.00
External Blip mount for aero extensions and base bars - 360 degree rotation for adjustment - Aero use only to fit 22.2mm OD bar 65mm in length - Fits all Zipp aero extensions and base bars - Blips not included - Weight: 57 grams for pair (does not include Blip) - Material: Polypropylene + TPE - Compatibility: 11-speed - Recommended Group: SRAM RED eTap
KMC Digital Chain Checker
$99.00
KMC's digital ChainChecker is the most accurate tool for checking your chain’s elongation. - Measures up to 2.5mm elongation - Fits all chains including 11 speed - Handy electronic device - Stainless hardened metal body
Garmin Running Dynamics Pod
$69.99
Computes and Transmits Meaningful Data - Computes and sends 6 running dynamics metrics to your compatible device - Battery life: replaceable battery lasts up to 1 year (assuming 1 hour daily use) - Automatically turns itself on and off - Tiny size: at less than 0.5 ounces, you'll forget it's there - Compatible devices connect with the Garmin Connect Mobile app to automatically sync your data and connect with others Train Hard, Run Free The Running Dynamics Pod easily clips onto your waistband to measure the running dynamics you need to beat yesterday. It gives you the option to run without a heart rate monitor chest strap. Once paired with your compatible smartwatch, just clip it to the back and center of your waistband and start your run. Review Your Form View and analyze important running metrics such as your cadence, stride length, ground contact time and balance, vertical oscillation and vertical ratio. These biomechanical measurements can help you understand your running form so you can perform better on race day. How It Works: The Running Dynamics Pod has an accelerometer in the module that measures torso movement to calculate these 6 running metrics: - Cadence is the number of steps per minute. It displays the total steps (right and left combined). - Ground contact time balance displays the left/right balance of your ground contact time while running. It displays a percentage. For example, 53.2 with an arrow pointing left or right. - Stride length is the length of your stride from 1 footfall to the next. It is measured in meters. - Vertical oscillation is your bounce while running. It displays the vertical motion of your torso, measured in centimeters for each step. - Vertical ratio is the ratio of vertical oscillation to stride length. It displays a percentage. A lower number typically indicates better running form. - Ground contact time is the amount of time in each step that you spend on the ground while running. It is measured in milliseconds.
K-Edge GO BIG Pro Handlebar Universal Mount (1/4x20)
$49.99
The K-EDGE Universal Camera 1/4-inch-20 Pro Handlebar Mount provides a solid platform for any camera that has a standard threaded 1/4-inch-20 (tripod) interface. Cameras Include: Garmin, SONY, Contour, Drift, Rollei, or almost any camera. - STRONG: CNC machined aluminum mount gives a rigid (over/under) platform - COMPATIBLE: Universal Mounting system for the majority of cameras. - POSITIVE: designed and produced to confidently lock your camera securely. - PRO: Highest quality and lightest weight design is ideal for carbon bars. Specifications: - Compatibility: Cameras with 1/4-inch-20 Interface, Ideal for carbon fiber or aluminum handlebars and all seat rails. - Material: CNC machined 6061-T6 Aluminum, Stainless Steel 1/4-inch-20 Thumbscrew - Weight: 46 grams - Made in Boise, Idaho, USA
Bontrager Interchange Analog Sensor
$17.99
Quickly and easily swap your Bontrager or Trek cycling computers and wireless sensors between bicycles without tools with these silicone mounting straps. Large and small sizes ensure proper fit on most forks. • Designed for Bontrager and Trek analog wireless computers • Interchange analog wireless sensor installs and removes in seconds without tools • Interchange sensor includes both L and S silicone mounting straps to fit most forks • Batteries can be found in computer accessories
Garmin Bike Speed Sensor
$39.99
Monitor your speed as you ride with Garmin's easy-to-install wireless sensor. The speed sensor attaches to the hub of either wheel and self-calibrates with your Garmin device to give you accurate speed and distance at all times, including indoors on the trainer. Simply attach the sensor and ride. With no magnets or other exposed parts to line up, this sensor is easy to install, maintain, and move between bikes.
Pro Vibe Aero Race Mount
$74.99
The Vibe Aero Race Mount is designed for the PRO Vibe Aero handlebar/stem combination. Made of high-quality CNC machined 6061-T6 Aluminum, it fits all Pro handlebar/stem combinations. - Compatibility (Regular): GARMIN 820, 520, 25, 20 - Compatibility (XL): GARMIN 1030, 1000, 820, 520, 25, 20 - Lifetime Guarantee - Weight: 30g
BiKASE TraiKASE with Q/R 360 degree bracket
$49.99
Universal phone holder with quick release bracket for diameters 24mm to 38mm and works great with any phone. Fits with aftermarket cases for phones such as iPhone X, iPhone 6,7,8 & iPhone X, XR, XS, X Max, X Max R. Holder is on a ball socket so can rotate 360 degree’s for viewing at any angle. Can use as an out front mount and comes in handy when you have lights, or other devices mounted on handlebar, because will provide a few inches of clearance from bar. Works on Bicycles, E-Bikes, ATV’s, Motorcycles, Snowmobiles, and UTV’s.
Bryton Smart Speed Sensor
$39.95
Smart Speed Sensor applies both ANT+ and Bluetooth technology. It wirelessly transmits your speed data to cycling computers and smart phones. With no magnets or exposed parts to line up, it is much easier to install. Easy to Use - Smart Speed Sensor is magnet-free and super easy to use and install as well as maintain and move between bikes. Dual Support - Featuring the application of both ANT+ and Bluetooth technologies, the Smart Speed Sensor is able to connect to both cycling computers and smart phones, making it compatible with most devices in the market. Improve Yourself - Designed to help you monitor both outdoor and indoor training, it can be combined to improve your personal best or compete with other cyclists.
CatEye Strada Speed Sensor Kit ISC-10
$63.99
Speed/Cadence Sensor Parts Kit for Strada Digital RD410DW, RD420DW, RD430DW, and V3n.
Knog PWR Helmet/GoPro Mount
$14.95
PWR Helmet/GoPro Mount - for holding charger and modular lights on top of helmet (Excludes PWR Mountain). Tri-prong system works with GoPro, so can be used to mount lights under Garmin and other mounts. - Compatibility: Works with PWR Charge and Modular lights (not PWR Mountain) - Mounting system: Designed to fit most vented helmets, common for road and trail cycling and is GoPro compatible - T Slot (For modular): Allows for quick release of the light when parking your bike - Weight: 20g
Bontrager 4mm Cadence Band Magnet
$7.99
Get your computer dialed with the perfect magnet Getting the correctly sized magnets means you're worrying about where the next coffee stop is, not if your computer is recording the ride. - Universal crank magnets sized for your bike and sensor - Compatible with all cadence sensors
Origin8 Handlebar Mount for Garmin Computers
$28.99
• Handlebar mount for Garmin Edge 200, 500, and 800 • Fits handlebars 22.2 to 31.8mm (Shims included) • Forged and CNC`d alloy construction
Bontrager Blendr SRM Mount
$24.99
Blendr is the ultimate integration system for clean and easy installation of lights, computers, and other accessories. Start with a Blendr stem, add the appropriate base, and finish with the Blendr SRM Mount for a clean, flush look that places your SRM Head Unit exactly where you want it. Key features: - Blendr is an elegant, integrated accessory mounting solution - Provides clean and secure mount for SRM head unit - Works with any Blendr-compatible stem and the accompanying base - For use with Blendr bases (Pro, XXX, XXX bar/stem, and select Elite bases)
CatEye RD300W Speed Sensor
$25.00
This Sensor works with the Strada Wireless RD300, Strada Wireless Universal CC-RD310W, Micro Wireless CC-MC200W, Urban Wireless CC-VT240W, and Urban Wireless + CC-VT245W.
Garmin Edge 510 Silicone Case
$9.99
Protect your Garmin Edge 510 with a form-fitting, silicone case and keep your mind at ease. Choose from a variety of cool colors to match your personal style.
Garmin O-Ring Band Kit
$5.99
Use Garmin's elastic bands with your quarter-turn bike mount to attach your compatible Edge to your bicycle's stem or handlebars.
FSA Control Center Computer Mount
$20.99
- Control Center computer mount for any 31.8mm handlebar - Dual clamps provide superior holding power, excellent for GPS units
Page 1 of 6 Next page